Super high frequency (SHF) is the ITU designation for radio frequencies (RF) in the range between 3 and 30 gigahertz (GHz). This band of frequencies is also known as the centimetre band or centimetre wave as the wavelengths range from one to ten centimetres. These frequencies fall within the microwave band, so radio waves with these frequencies are called microwaves. The small wavelength of microwaves allows them to be directed in narrow beams by aperture antennas such as parabolic dishes and horn antennas, so they are used for point-to-point communication and data links[1] and for radar. This frequency range is used for most radar transmitters, wireless LANs, satellite communication, microwave radio relay links, and numerous short range terrestrial data links. They are also used for heating in industrial microwave heating, medical diathermy, microwave hyperthermy to treat cancer, and to cook food in microwave ovens.
Frequencies in the SHF range are often referred to by their IEEE radar band designations: S, C, X, Ku, K, or Ka band, or by similar NATO or EU designations.
Propagation
A variety of parabolic antennas on a communications tower in Australia for point-to-point microwave communication links. Some have white plastic radomes over their apertures to protect against rain.
X-band (8 - 12 GHz) marine radar antenna on a ship. The rotating bar sweeps a vertical fan-shaped beam of microwaves around the water surface to the horizon, detecting nearby ships and other obstructions
Microwaves propagate solely by line of sight; because of the small refraction due to their short wavelength, the groundwave and ionospheric reflection (skywave or "skip" propagation) seen with lower frequency radio waves do not occur.[2] Although in some cases they can penetrate building walls enough for useful reception, unobstructed rights of way cleared to the first Fresnel zone are usually required. Wavelengths are small enough at microwave frequencies that the antenna can be much larger than a wavelength, allowing highly directional (high gain) antennas to be built which can produce narrow beams. Therefore, they are used in point-to-point terrestrial communications links, limited by the visual horizon to 30–40 miles (48–64 km). Such high gain antennas allow frequency reuse by nearby transmitters. The wavelength of SHF waves creates strong reflections from metal objects the size of automobiles, aircraft, and ships, and other vehicles. This and the narrow beamwidths possible with high gain antennas and the low atmospheric attenuation as compared with higher frequencies make SHF the main frequencies used in radar. Attenuation and scattering by moisture in the atmosphere increase with frequency, limiting the use of high SHF frequencies for long range applications.
Small amounts of microwave energy are randomly scattered by water vapor molecules in the troposphere. This is used in troposcatter communications systems, operating at a few GHz, to communicate beyond the horizon. A powerful microwave beam is aimed just above the horizon; as it passes through the tropopause some of the microwaves are scattered back to Earth to a receiver beyond the horizon. Distances of 300 km can be achieved. These are mainly used for military communication.
Antennas
Microwaves are often carried by waveguide, such as this example from an air traffic control radar, since other types of cable have large power losses at SHF frequencies.
The wavelengths of SHF waves are small enough that they can be focused into narrow beams by high gain antennas from a half meter to five meters in diameter. Directive antennas at SHF frequencies are mostly aperture antennas, such as parabolic antennas (the most common type), dielectric lens, slot and horn antennas. Large parabolic antennas can produce very narrow beams of a few degrees or less, and often must be aimed with the aid of a boresight. For omnidirectional applications like wireless devices and cellphones, small dipoles or monopoles are used. The patch antenna is another type, often integrated into the skin of aircraft. Another type of antenna practical at microwave frequencies is the phased array, consisting of many dipoles or patch antennas on a flat surface, each fed through a phase shifter, which allows the array's beam to be steered electronically. The short wavelength requires great mechanical rigidity in large antennas, to ensure that the radio waves arrive at the feed point in phase.
Waveguide
At microwave frequencies, the types of cable (transmission line) used to conduct lower frequency radio waves, such as coaxial cable, have high power losses. Therefore, to transport microwaves between the transmitter or receiver and the antenna with low losses, a special type of metal pipe called waveguide must be used. Because of the high cost and maintenance requirements of long waveguide runs, in many microwave antennas the output stage of the transmitter or the RF front end of the receiver is located at the antenna.
Advantages
SHF frequencies occupy a "sweet spot" in the radio spectrum which is currently being exploited by many new radio services.[3] They are the lowest frequency band where radio waves can be directed in narrow beams by conveniently sized antennas so they do not interfere with nearby transmitters on the same frequency, allowing frequency reuse. On the other hand, they are the highest frequencies which can be used for long distance terrestrial communication; higher frequencies in the EHF (millimeter wave) band are highly absorbed by the atmosphere, limiting practical propagation distances to one kilometer. The high frequency gives microwave communication links a very large information-carrying capacity (bandwidth). In recent decades many new solid state sources of microwave energy have been developed, and microwave integrated circuits for the first time allow significant signal processing to be done at these frequencies. Sources of EHF energy are much more limited and in an earlier state of development.
See also
Knife-edge effect
Microwave burn
References
Freedman, S. (September 1946). "Two-way radio for everyone" (PDF). Radio News. New York: Ziff-Davis Publications. 36 (3): 25–27. Retrieved March 24, 2014. This article from the beginning of the microwave era predicted the future value of microwaves for point-to-point communication.
Seybold, John S. (2005). Introduction to RF Propagation. John Wiley and Sons. pp. 55–58. ISBN 0471743682.
Lee, Thomas H. (2004). Planar Microwave Engineering: A Practical Guide to Theory, Measurement, and Circuits. Cambridge University Press. p. 27. ISBN 1316175774.
External links
Tomislav Stimac, "Definition of frequency bands (VLF, ELF... etc.)". IK1QFK Home Page (vlf.it).
Inés Vidal Castiñeira, "Celeria: Wireless Access To Cable Networks"
vte
Radio spectrum (ITU)
ELF
3 Hz/100 Mm
30 Hz/10 Mm
SLF
30 Hz/10 Mm
300 Hz/1 Mm
ULF
300 Hz/1 Mm
3 kHz/100 km
VLF
3 kHz/100 km
30 kHz/10 km
LF
30 kHz/10 km
300 kHz/1 km
MF
300 kHz/1 km
3 MHz/100 m
HF
3 MHz/100 m
30 MHz/10 m
VHF
30 MHz/10 m
300 MHz/1 m
UHF
300 MHz/1 m
3 GHz/100 mm
SHF
3 GHz/100 mm
30 GHz/10 mm
EHF
30 GHz/10 mm
300 GHz/1 mm
THF
300 GHz/1 mm
3 THz/0.1 mm
vte
Electromagnetic spectrum
Gamma rays X-rays Ultraviolet Visible Infrared Microwave Radio
Frequency vs. wave length.svg
← higher frequencies longer wavelengths →
X-rays
soft X-ray hard X-ray
Ultraviolet
Extreme ultraviolet Vacuum ultraviolet Lyman-alpha FUV MUV NUV UVC UVB UVA
Visible (optical)
Violet Blue Cyan Green Yellow Orange Red
Infrared
NIR SWIR MWIR LWIR FIR
Microwaves
W band V band Q band Ka band K band Ku band X band C band S band L band
Radio
THF EHF SHF UHF VHF HF MF LF VLF ULF SLF ELF
Wavelength types
Microwave Shortwave Medium wave Longwave
Hellenica World - Scientific Library
Retrieved from "http://en.wikipedia.org/"
All text is available under the terms of the GNU Free Documentation License
