A photonic integrated circuit (PIC) or integrated optical circuit is a device that integrates multiple (at least two) photonic functions and as such is similar to an electronic integrated circuit. The major difference between the two is that a photonic integrated circuit provides functions for information signals imposed on optical wavelengths typically in the visible spectrum or near infrared 850 nm-1650 nm.
The most commercially utilized material platform for photonic integrated circuits is indium phosphide (InP), which allows for the integration of various optically active and passive functions on the same chip. Initial examples of photonic integrated circuits were simple 2-section distributed Bragg reflector (DBR) lasers, consisting of two independently controlled device sections - a gain section and a DBR mirror section. Consequently, all modern monolithic tunable lasers, widely tunable lasers, externally modulated lasers and transmitters, integrated receivers, etc. are examples of photonic integrated circuits. As of 2012, devices integrate hundreds of functions onto a single chip.[1] Pioneering work in this arena was performed at Bell Laboratories. Most notable academic centers of excellence of photonic integrated circuits in InP are the University of California at Santa Barbara, USA, and the Eindhoven University of Technology in the Netherlands.
A 2005 development[2] showed that silicon can, even though it is an indirect bandgap material, still be used to generate laser light via the Raman nonlinearity. Such lasers are not electrically driven but optically driven and therefore still necessitate a further optical pump laser source.
Comparison to electronic integration
Unlike electronic integration where silicon is the dominant material, system photonic integrated circuits have been fabricated from a variety of material systems, including electro-optic crystals such as lithium niobate, silica on silicon, Silicon on insulator, various polymers and semiconductor materials which are used to make semiconductor lasers such as GaAs and InP. The different material systems are used because they each provide different advantages and limitations depending on the function to be integrated. For instance, silica (silicon dioxide) based PICs have very desirable properties for passive photonic circuits such as AWGs (see below) due to their comparatively low losses and low thermal sensitivity, GaAs or InP based PICs allow the direct integration of light sources and Silicon PICs enable co-integration of the photonics with transistor based electronics.[3]
The fabrication techniques are similar to those used in electronic integrated circuits in which photolithography is used to pattern wafers for etching and material deposition. Unlike electronics where the primary device is the transistor, there is no single dominant device. The range of devices required on a chip includes low loss interconnect waveguides, power splitters, optical amplifiers, optical modulators, filters, lasers and detectors. These devices require a variety of different materials and fabrication techniques making it difficult to realize all of them on a single chip.
Newer techniques using resonant photonic interferometry is making way for UV LEDs to be used for optical computing requirements with much cheaper costs leading the way to petahertz PHz consumer electronics.
Examples of photonic integrated circuits
The primary application for photonic integrated circuits is in the area of fiber-optic communication though applications in other fields such as biomedical and photonic computing are also possible.
The arrayed waveguide grating (AWG) which are commonly used as optical (de)multiplexers in wavelength division multiplexed (WDM) fiber-optic communication systems are an example of a photonic integrated circuit which has replaced previous multiplexing schemes which utilized multiple discrete filter elements. Since separating optical modes is a need for quantum computing, this technology may be helpful to miniaturize quantum computers (see linear optical quantum computing).
Another example of a photonic integrated chip in wide use today in fiber-optic communication systems is the externally modulated laser (EML) which combines a distributed feed back laser diode with an electro-absorption modulator [4] on a single InP based chip.
Current status
Photonic integration is currently an active topic in U.S. Defense contracts.[5][6] It is included by the Optical Internetworking Forum for inclusion in 100 gigahertz optical networking standards.[7]
See also
Optical computing
Optical transistor
Notes
Larry Coldren; Scott Corzine; Milan Mashanovitch (2012). Diode Lasers and Photonic Integrated Circuits (Second ed.). John Wiley and Sons. ISBN 9781118148181.
Rong, Haisheng; Jones, Richard; Liu, Ansheng; Cohen, Oded; Hak, Dani; Fang, Alexander; Paniccia, Mario (February 2005). "A continuous-wave Raman silicon laser" (PDF). Nature. 433 (7027): 725–728. Bibcode:2005Natur.433..725R. doi:10.1038/nature03346. PMID 15716948. S2CID 4429297. Archived from the original (PDF) on 2013-07-24.
Narasimha, Adithyaram; Analui, Behnam; Balmater, Erwin; Clark, Aaron; Gal, Thomas; Guckenberger, Drew; Gutierrez, Steve; Harrison, Mark; Ingram, Ryan; Koumans, Roger; Kucharski, Daniel; Leap, Kosal; Liang, Yi; Mekis, Attila; Mirsaidi, Sina; Peterson, Mark; Pham, Tan; Pinguet, Thierry; Rines, David; Sadagopan, Vikram; Sleboda, Thomas J.; Song, Dan; Wang, Yanxin; Welch, Brian; Witzens, Jeremy; Abdalla, Sherif; Gloeckner, Steffen; De Dobbelaere, Peter (2008). "A 40-Gb/s QSFP optoelectronic transceiver in a 0.13 µm CMOS silicon-on-insulator technology". Proceedings of the Optical Fiber Communication Conference (OFC): OMK7. doi:10.1109/OFC.2008.4528356. ISBN 978-1-55752-856-8. S2CID 43850036.
Encyclopedia of Laser Physics and Technology - electroabsorption modulators, electro-absorption modulators
"Silicon-based Photonic Analog Signal Processing Engines with Reconfigurability (Si-PhASER) - Federal Business Opportunities: Opportunities". Fbo.gov. Retrieved 2013-12-21.
"Centers in Integrated Photonics Engineering Research (CIPhER) - Federal Business Opportunities: Opportunities". Fbo.gov. Retrieved 2013-12-21.
CEI-28G: Paving the Way for 100 Gigabit
References
Larry Coldren; Scott Corzine; Milan Mashanovitch (2012). Diode Lasers and Photonic Integrated Circuits (Second ed.). John Wiley and Sons. ISBN 9781118148181.
McAulay, Alastair D. (1999). Optical Computer Architectures: The Application of Optical Concepts to Next Generation Computers.
Guha, A.; Ramnarayan, R.; Derstine, M. (1987). "Architectural issues in designing symbolic processors in optics". Proceedings of the 14th annual international symposium on Computer architecture - ISCA '87. p. 145. doi:10.1145/30350.30367. ISBN 0818607769. S2CID 14228669.
Altera Corporation (2011). "Overcome Copper Limits with Optical Interfaces" (PDF).
Brenner, K.-H.; Huang, Alan (1986). "Logic and architectures for digital optical computers (A)". J. Opt. Soc. Am. A3: 62. Bibcode:1986JOSAA...3...62B.
Brenner, K.-H. (1988). "A programmable optical processor based on symbolic substitution". Appl. Opt. 27 (9): 1687–1691. Bibcode:1988ApOpt..27.1687B. doi:10.1364/AO.27.001687. PMID 20531637.
Hellenica World - Scientific Library
Retrieved from "http://en.wikipedia.org/"
All text is available under the terms of the GNU Free Documentation License
